TORTOISE TABLE INSTRUCTIONS All three lines are built in the same way. Please follow these instructions to build the unit. 1. Remove all the items from the box. 2. With the help of another, stand one of the arc shaped end panels upright and then attach the two top thin lengths with 2 screws provided. 3. Attach the other arc shaped panel to the opposite end and again screw the pieces together. 4. Now do the same again with the thicker lengths half way down the unit so you will end up with two end panels and four cross lengths. Be sure to use the correct parts here so the plastic tray will slide in from the front and stop with the welded blocks fixed to the back length. 5. Add the two short lengths from front to back between the arc shaped panels. 6. Add the four wheels provided, these may need to be pushed very hard into the gromit holder, then add the plastic tray. 7. Add the wire top panel if required. 8. Add the wire play area around and below the tray if required, this will slot into holder circles welded to the upright arc panels. |
